Software update: RouterOS 6.42.2

Spread the love

MikroTik has released RouterOS 6.42.2. RouterOS is an operating system that focuses on the execution of router tasks think of routing network traffic, but also a firewall, bandwidth management, controlling wireless access points, a hotspot gateway and a vpn server. It can work on the hardware by MikroTik as well as on x86 or virtual machines. A license which is included in the purchase of MikroTik hardware, is required for use. The list of changes for this release is as follows:

What’s new in 6.42.2:

  • bridge – do not allow to add same interface to bridge more than once;
  • bridge – fixed LLDP packet
  • bridge – fixed processing or fragmented packets when hardware offloading is enabled;
  • console – fixed type “on” and “wireless status” LED trigger value setting (introduced in v6.42.1);
  • crs317 – fixed link flapping when inserted S + RJ10 module without any cable;
  • defconf – fixed wAP LTE kit default configuration;
  • dhcpv4 – prevent sending out ICMP port unreachable packets;
  • dhcpv4 client – fixed DHCP client stuck in renewing state;
  • dhcpv6-relay – fixed missing configuration after reboot;
  • filesystem – fixed NAND memory going into read-only mode;
  • hotspot – fixed user authentication when queue from old session is not removed yet;
  • interface – fixed “built-in = no” parameter for manua lly created interface lists;
  • interface – fixed “dynamic” built-in interface list behavior;
  • interface – fixed interface list which include disabled member;
  • interface – fixed interface list which include / exclude another list; 19659004] interface – fixed interface configuration responsiveness;
  • ipsec – fixed policies becoming invalid
  • ipsec – improved reliability on IPsec hardware encryption for ARM devices except RB1100Dx4;
  • led – added “dark -mode “functionality for hAP ac and hAP ac ^ 2 devices;
  • lte – improved LTE communication process on MMIPS platform devices;
  • quickset – fixed dual radio mode detection process;
  • router board – properly represent board name for hap ac ^ 2;
  • tile – fixed Ethernet interfaces becoming unresponsive;
  • winbox – allow to specify “any” as wireless “access-list” interface;
  • winbox – fixed “/ ip dhcp-server network set dns-none “parame
  • wireless – enable all chains by default on devices without external antennas after configuration reset;
  • wireless – fixed packet processing when “static – algo – 0 = 40bit – wep” is being used (in v6.42 )
  • wireless – fixed usage of allowed signal strength values ​​received from RADIUS
  • wireless – improved wireless throughput on hAP ac ^ 2 and cAP ac;
  • x86 – fixed reboot caused by MAC Winbox connection; [19659033]

     

You might also like